51-927EP: Pollak Master Disconnect Switch SPST, Off/On, 1/2 inch Copper Studs

Master Disconnect Switch

• Lever Operated
• 6-36 Volt
• 180 Amps continuous capacity @ 12V; 1800 amps in Rush @ 12V (4 seconds ON / 20 Minuties OFF. Use #00-ga wire size or larger for 1800 Amp application.
• S.P.S.T. (Off-On)
• Two stud terminals for battery circuit only. Does not disconnect alternator or generator field circuit. On vehicles equipped with alternators, engineer must be shut off to avoid potential damage to alternator diodes.
• Incorporates heavy duty contacts
• One piece die-cast housing sealed with O-rings at base and mounting stem to keep out dust and moisture
• Large die-cast, lever for ease of operation
• Two 1/2-inch copper alloy stud terminals with hex nuts and lock washers
• Overall length 4 3/8". Diameter 2 5/8" approx
• Conforms to requirements of U.L. #558
• Mounting stem 3/4" diameter, l/2" long, with two hexnuts and lock washer. (Note: Mounting nuts not to exceed 12 ft. Ibs. torque)
• Designed for protection against battery drain, electrical fires, tampering and theft
• Fits panels up to l/4" thick

PARTS CROSS-OVER TABLE